Publications Nationales

Permanent URI for this collectionhttps://dspace.univ-boumerdes.dz/handle/123456789/14

Browse

Search Results

Now showing 1 - 8 of 8
  • Item
    The degradation of methylene blue by bacterial strains isolated from the peel of Red Beet
    (Université M'Hamed Bougara Boumerdes, 2018) Abai, N.; Abed, F.; Babakhouya, N.; Benrachdi, K.
    The textile industry generates half of the industrial pollution flows, these effluents can be very colorful and difficult to treat. The treatment of these effluents has become a priority in the world, the development of methods and the optimization of existing processes, are the subject of a large number of works. In the present work the methylene blue was degraded by two bacterial strains BP1 and BP2 isolated from the peel of red beet, identified as Acinetobacter Johnson II BP1 and BP2 as Bacillus weihenstephanensis. The effect of the initial concentration, pH, temperature, and addition of the carbon source and nitrogen source on the biodegradation of the dye was determined.
  • Item
    Study of the adsorption of methylene blue by natural materials (olive stone, date pit and their mixture) in fixed bed column
    (ALJEST, 2019) Abed, Fatma; Aksa, H.; Abai, N.; Babakhouya, N.
    The present study focuses on the recovery of two agro-food waste available in our country with significant quantities olive pomace and date pits for the removal of a synthetic dye which is methylene blue. Both materials were used in their native forms separated and mixed to improve their adsorptive capacity. A range of physico-chemical analysis was performed to characterize adsorbents used, among them: the FTIR spectroscopy and the scanning electron microscopy. The ability of adsorbents prepared to adsorbe methylene blue (MB) from the aqueous solution was investigated in a fixed bed column. The effects of several important parameters were studied, such as initial concentration of MB, flow rate and bed height. The corresponding breakthrough curves were calculated.
  • Item
    Feasibility study of adsorption of a textile dye on activated carbon prepared starting from the coffee grounds
    (Aljest, 2017) Mahdi, K.; Benrachedi, K.
    The activated carbon used in this study is prepared starting from the coffee ground whose abundance is important in our country and of which the use is often limited to food consummation. The physical characterization (porosity and surface) was determined by the adsorption of gas nitrogen to 77 K (BET), showed the presence of macropores (1.77 m2 /g), as well as the analysis by electronic scan microscopy MEB revealed the presence of a broad specific surface. The activated carbon obtained starting from the coffee ground was the object of an application to the aqueous medium for tests of elimination of a cation dye (methylene blue) used in the industry of textile, prepared synthetically. Several parameters were studied in order to optimize the ideal conditions for a good adsorption of the pollutant to study; in particular, the kinetics of adsorption, the effect of the initial concentration and the effect of the pH of the solution examined. The simulated isotherms of adsorption are very correctly described by the models of Langmuir and Freundlich. The percentage of discolouration reached is of: 99%. Therefore, one can conclude that this study showed that the coffee ground chemically activated can be used like new adsorbent for the water treatment contaminated by the textile dyes
  • Item
    The degradation of methylene blue by bacterial strains isolated from the peel of Red Beet
    (Aljest, 2019) Abai, Nadjet; Abed, F.; Babakhouya, N.; Benrachdi, K.
    The textile industry generates half of the industrial pollution flows, these effluents can be very colorful and difficult to treat. The treatment of these effluents has become a priority in the world, the development of methods and the optimization of existing processes, are the subject of a large number of works. In the present work the methylene blue was degraded by two bacterial strains BP1 and BP2 isolated from the peel of red beet, identified as Acinetobacter Johnson II BP1 and BP2 as Bacillus weihenstephanensis. The effect of the initial concentration, pH, temperature, and addition of the carbon source and nitrogen source on the biodegradation of the dye was determined
  • Item
    Removal of methylene blue in aqueous solution by oxidation with hydrogen peroxide in presence of copper-impregnated activated alumina
    (Aljest, 2019) Bousalah, Djedjiga; Yeddou, A. R.; Hachemi, M.; Nadjemi, B.
    In this work, methylene blue in aqueous solution is removed by oxidation with hydrogen peroxide in the presence of copper impregnated activated alumina. After preparation and characterization of the catalyst, the catalytic oxidation tests are performed. The effects of pH, H2O2 concentration, catalyst dose, and temperature have been investigated. The tests show that adding activated alumina increases significatively the degradation effeciency of methylene blue. The reuse of catalyst for four cycls shows a good catalytic stability. The elevation of the temperature affects positively the kinetics of degradation. The acidified medium increases the decolorization efficiency of dye.
  • Item
    Study of the adsorption of methylene blue by natural materials (olive stone, date pit and their mixture) in fixed bed column
    (Aljest, 2019) Abed, F.; Louhab, K.; Abai, Nadjet; Babakhouya, N.
    The present study focuses on the recovery of two agro-food waste available in our country with significant quantities olive pomace and date pits for the removal of a synthetic dye which is methylene blue. Both materials were used in their native forms separated and mixed to improve their adsorptive capacity. A range of physico-chemical analysis was performed to characterize adsorbents used, among them: the FTIR spectroscopy and the scanning electron microscopy. The ability of adsorbents prepared to adsorbe methylene blue (MB) from the aqueous solution was investigated in a fixed bed column. The effects of several important parameters were studied, such as initial concentration of MB, flow rate and bed height. The corresponding breakthrough curves were calculated
  • Item
    Removal in batch mode experiment of Methylene Blue onto trimming Wood of Orange Tree –Equilibrium and Kinetics Studies –
    (ALJEST, 2018) Sifoun, Naima; Abbas, Moussa; Yeddou, A. R.; Nouri, L.; Nadjemi, B.
    In the present study, adsorption of Methylene Blue (MB) from aqueous solution was investigated using an adsorbent derived from Trimming Wood of Orange Tree (WOT). The used adsorbent was analyzed using FT-IR and SEM techniques.The adsorption of MB was carried out using a batch system and the effects of adsorbent dose, initial pH, ionic strength, contact time, initial concentration and temperature on the adsorption capacity of adsorbent were investigated. Kinetic parameters, rate constants, equilibrium adsorption capacities and determination coefficients, for each kinetic equation were calculated and discussed. It was shown that the adsorption of MB onto WOT could be described by the pseudo-second order kinetic. The experimental isotherm data were analyzed using the Langmuir, Freundlich and Temkin models. Adsorption of MB onto WOT followed the Langmuir isotherm for all temperatures studied and the maximum MB uptake was observed as 48.78 mg/g at 293 K. The evaluation of thermodynamics parameters such as the negative Gibbsfree energy and negative enthalpy change indicated respectively the spontaneous and exothermic nature of thesorptionprocess
  • Item
    Modeling of adsorption isotherms of methylene blue by olive ‎stones
    (Aljest, 2015) Abed, F.; Babakhouya, N.; Boughrara, S.
    The present study focuses on the recovery of the waste food « the ‎olive stones » in the field of industrial liquid effluent treatment. The ‎material is used in its native form. In order to test the ‎performances of the adsorbent we were interested in cationic dye ‎the methylene blue considered as pollutant. The effects of several ‎parameters such as contact times, initial concentration of dye, ‎solution and pH were studied in batch system.‎ Modeling of experimental results was performed using models of ‎Langmuir and Freundlich isotherms, which show that adsorption ‎follows the Langmuir model with high correlation coefficients