Publications Scientifiques

Permanent URI for this communityhttps://dspace.univ-boumerdes.dz/handle/123456789/10

Browse

Author: search.filters.author.Bououdina, M.Subject: search.filters.subject.CCTO

Search Results

Now showing 1 - 2 of 2
  • No Thumbnail Available
    Item
    Dielectric properties of nanocrystalline CaCu3Ti4O12 (CCTO) ceramics fabricated from Algerian limestone raw material
    (Elsevier, 2023) Djafar, Rabah; Boumchedda, K.; Fasquelle, D.; Chaouchi, A.; Sedda, K.; Bououdina, M.; Bellucci, S.; Bánhegyi, G.
    Algerian natural limestone was used to fabricate the perovskite CaCu3Ti4O12 phase (CCTO) to replace commercial calcium carbonate (CaCO3) powder by a solid-state method. X-ray diffraction analysis of CCTO ceramics sintered at 1010 °C manifested the formation of well-crystallized pure (CCTO) phase with narrow crystallite size (43–99 nm) without any additional phases after sintering beyond 4 h. Thermal analysis by DSC indicated that CCTO phase is stable up to 1151 °C, afterwards it decomposes into CaTiO3 and TiO2 and accompanied by the segregation of the CuO/Cu2O phase. Scanning electron microscopy observations of the ceramics sintered at 1010 °C showed that most of the grains have an average particle size in the narrow range of 1–2 μm. The sintered pellet at 1010 C° for 14 h showed the optimum density (>94%). This study highlights the importance of using natural calcium carbonates (extracted from Guelma limestone in Algeria) as potential replacement to commercial counterpart for the fabrication of dense well-crystallized perovskite-type ceramics with controlled particle size distribution as promising candidates for electronic applications
  • No Thumbnail Available
    Item
    Cu2O addition and sintering temperature dependence of structural, microstructural and dielectric properties of CaCu3Ti4O12 ceramics
    (Elsevier, 2020) Djafar, Rabah; Boumchedda, K.; Chaouchi, A.; Fasquelle, D.; Sedda, K.; Brahimi, S.; Khalfaoui, K.; Bououdina, M.
    This study is aimed in the replacement of commonly used (CuO) by Cu2O in the synthesis of perovskite CaCu3Ti4O12 (CCTO) phase by the solid-state reaction method. The XRD analysis of powder calcined at 1100 °C and ceramics sintered at different temperatures show that the CCTO phase was well crystallized with the presence of small quantities of additional phases. The SEM/EDS analysis of prepared pellets show that the formation of Cu2O/CuO phase occurs above 950 °C, resulting in enhanced densification at 1050 °C (>96%). However, it is found that the Cu2O-based CCTO begins to degrade around 1090 °C. The densification after sintering at 1050 °C reaches 96%, meanwhile dielectric constant and loss tangent values are optimum in the low frequency range (<103 Hz); i.e. 13378 and 0.177, respectively. This favors the use of Cu2O instead of CuO in CCTO ceramics for applications at low frequencies